Mountfield 2135H Manuel d'instructions télécharger pdf (Page 15)

ENGLISH

7.7.2 Adjustment

Tension the steering cables by tightening up the

nut (19:R). Important! The screws in the ends of

the cable should be held firmly during adjustment

so that the cable is not twisted. Using an adjustable

wrench or similar, grasp the key handle on the

screws in the ends of the cable.

Adjust the steering cables until all play is removed.

Do not tension the steering cables too hard.

Otherwise the steering will be heavy and wear and

tear on the cables will increase.

7.8 BATTERY

Never overcharge the battery.

Overcharging can damage the battery.

Do not short-circuit the battery’s

terminals. Sparks occur which can

result in fire. Do not wear metal

jewellery which can come into contact

with the battery terminals.

In the event of damage to the battery

casing, cover, terminals or interference

to the strip covering the valves, the

battery should be replaced.

The battery is a valve-regulated battery with 12 V

nominal voltage. The battery fluid does not need to

and cannot be checked or topped up. The only

maintenance that is required is charging, for

example after extended storage.

The battery must be fully charged

before being used for the first time. The

battery must always be stored fully

charged. If the battery is stored while

discharged, serious damage will occur.

7.8.1 Charging with the engine

The battery can be charged using the engine’s

generator as follows:

1. Install the battery in the machine as shown

below.

2. Place the machine outdoors or install an

extraction device for the exhaust fumes.

3. Start the engine according to the instructions in

the user guide.

4. Allow the engine to run continuously for 45

minutes.

5. Stop the engine. The battery will now be fully

charged.

7.8.2 Charging using battery charger

When charging using a battery charger, a battery

charger with constant voltage must be used.

Contact your dealer to purchase a battery charger

with constant voltage.

The battery can be damaged if a standard type

battery charger is used.

7.8.3 Removal/Installation

The battery is placed under the engine casing. See

fig. 17. During removal/installation of the battery,

the following applies regarding connection of the

cables:

• During removal. First disconnect the black

cable from the battery’s negative terminal (-).

Then disconnect the red cable from the

battery’s positive terminal (-).

• During installation. First connect the red cable

to the battery’s positive terminal (+). Then

connect the black cable to the battery’s negative

terminal (-).

If the cables are disconnected/

connected in the wrong order, there is a

risk of a short-circuit and damage to the

battery.

If the cables are interchanged, the

generator and the battery will be

damaged.

Tighten the cables securely. Loose

cables can cause a fire.

The engine must never be driven with

the battery disconnected. There is a risk

of serious damage to the generator and

the electrical system.

7.8.4 Cleaning

If the battery terminals are coated with oxide, they

should be cleaned. Clean the battery terminals with

a wire brush and lubricate them with terminal

grease.

7.9 AIR FILTER

It is very important that the air filter is

intact and correctly installed. Never

start the engine without the air filter or

if the air filter is defective.

7.9.1 Air filter (2125M)

The pre-filter (foam filter) (16:G) must be cleaned/

replaced every 25 operating hours.

The air-filter (paper filter) (16:F) must be cleaned/

replaced every 100 operating hours.

NOTE! Clean/replace the filter more often if

the machine operates in dusty conditions.

Remove/install the air filters as follows.

1. Clean carefully around the air filter housing

(15:E).

2. Remove the air filter cover by removing

releasing the two clamps at the rear edge of the

cover.

3. Remove the filters. The pre-filter is located far

in towards the engine. Make sure that no dirt

gets into the carburettor. Clean the air filter

housing.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 73 74

Commentaires sur ces manuels

Pas de commentaire

Mountfield 2135H Manuel d'instructions Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Tracteur Mountfield 2135H