Mountfield SV150 Spécifications télécharger pdf (Page 17)

6 Fit the other end of the cable in the conveyor

hole, securing it to the handle (5) with a knot.

7 Turn the pulley (3) and the cable (4) anticlock-

wise for approx. 5 complete revs to load the

spring, then release the pulley carefully to wind

the entire cable onto the pulley.

8 Check that the pulley (3) is free to rotate.

9 After pulling the entire length of the cable, check

that the pulley (3) is able to complete 2-3 turns

before compressing the spring.

10 Remount the internal screen (1).

11 Remount the conveyor [ 6.1.A

B) Replacing the hooks

21 Remove the conveyor with the tank [ 6.1.A

22 Loosen the central screw (6) and dismount the

bushing (7) and hooks (8) without letting the pul-

ley (3) slip out of place.

NOTE

The screw (6) has a left-handed thread and

therefore should be unscrewed clockwise.

NOTE

Always replace the hooks (8), the bushing (7)

and the screw (6) in one block.

23 Mount the new hooks (8), taking care to position

them correctly with the bushing (7) and the

guides in the pulley hub (3). Tighten the screw

(6) anticlockwise so that the pulley rotates

smoothly.

24 Remount the conveyor [ 6.1.A

C) Replacing the pulley

31 Remove the conveyor with the tank [ 6.1.A

32 Dismount the internal screen (1) fastened by the

screw (2).

SV 150

6.2.0

STARTING SYSTEM





2 / 3



WORKSHOP MANUAL

page

from

2004 to ••••

01/2005

<= ...BACK... <=

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Rel. 1.0 - 01/2005 1
WORKSHOP MANUAL 10

Commentaires sur ces manuels

Pas de commentaire

Mountfield SV150 Spécifications Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Moteur Mountfield SV150